Driveshaft balancing
Dynamic balancing of assembled driveshafts up to 6 m long and 500 kg in mass. Mounting and operating speed are confirmed during technical assessment.
Explore this serviceALWAZEN INDUSTRIES
Dynamic balancing
Driveshafts, industrial rotors and turbines. Measure imbalance, apply correction and verify the result against agreed requirements.
Explore the assembly3D / 360°
Drag to rotate · arrow keys and + / − also work
What we balance
Acceptance follows a review of mass, dimensions, bearing surfaces and mounting. On-site work also requires access and safe trial-running conditions to be assessed.
01
Driveshafts
Assembly balancing after repair or manufacture.
02Turbine rotors
Agree supports, measurement conditions and acceptance criteria.
03Fans and impellers
Workshop or on-site service after technical review.
04Crankshafts
Account for design, assembly completeness and required bobweights.
05Augers and screw rotors
Check geometry, supports and mounting feasibility.
06Mulcher rotors
Account for the condition and completeness of cutting elements.
07Discs, flywheels and pulleys
Check fits, runout and permitted correction methods.
08Industrial rotors
Electric motors, pumps and other rotating assemblies.
Balancing capabilities
Limits apply to dynamic balancing. Acceptance also depends on geometry, support surfaces and safe mounting.
Dynamic balancing
Rotor & turbine balancing
Dynamic balancing of rotors, fans, impellers and turbine rotors up to 500 kg, subject to technical review.
Explore this serviceDiagnostics. Alignment. On-site service.
Vibration diagnostics and analysis
Vibration measurement and analysis for rotating equipment to identify likely causes and determine the next maintenance steps.
Explore this serviceLaser shaft alignment
Check and correct shaft alignment in motors, pumps, gearboxes and other coupled machinery.
Explore this serviceOn-site dynamic balancing
Balance a rotor in its own bearings at the operating site, following a review of feasibility and safe working conditions.
Explore this serviceEquipment vibration monitoring
Track equipment vibration over time through periodic measurements or a project for continuous monitoring.
Explore this serviceWhy start with diagnosis?
Vibration may come from imbalance, worn joints, deformation, support condition or misalignment. Balancing does not replace the correction of mechanical defects.
- Assess the component and operating data
- Measure imbalance and agree the correction
- Verify the result after correction
04 / Service request
Start with your part.
Tell us what needs balancing or repair. Feasibility, cost and timing are confirmed after review. Sending a request does not confirm acceptance of the part for work.
info@alwazen.com