Fans and induced-draught fans
Impellers in ventilation, extraction and flue-gas systems.
ALWAZEN INDUSTRIES
On-site dynamic balancing
Balance a rotor in its own bearings at the operating site, following a review of feasibility and safe working conditions.
Explore the assembly3D / 360°
Drag to rotate · arrow keys and + / − also work
Scope and input data
What to prepare
Provide location, rotor type and mass, speed, symptoms and access to correction planes. Agree diagnosis, safe trial runs, correction method, downtime and final verification. On-site limits are assessed separately from workshop balancing capacity.
Agree the method, tolerances, checks and required records before work starts.
Balancing at your facility
Blowers and air movers
Rotating assemblies with access to measurement points and correction planes.
Process rotors
Balancing in the existing bearings is assessed following a site survey.
A clear route from request to handover.
- 01
Plan the visit
Review equipment data, site, access and the available shutdown window.
- 02
Diagnosis and trial runs
Assess condition and measure initial vibration at an agreed operating point.
- 03
Correct imbalance
Perform trial-weight measurements and the agreed correction.
- 04
Verify and report
Repeat measurements and record results, operating conditions and recommendations.
04 / Service request
Start with your part.
Tell us what needs balancing or repair. Feasibility, cost and timing are confirmed after review. Sending a request does not confirm acceptance of the part for work.
info@alwazen.com