Driveshaft repair
Repair and rebuilding using factory processes: inspection of joints, play and straightness, with component repair or replacement to the agreed scope.
Explore this serviceALWAZEN INDUSTRIES
Industrial services
A high-technology industrial enterprise combining engineering research, manufacturing and service. Deep digitalisation and global development. Driveshaft repair and manufacture, rotating assembly balancing, machining, fitting and welding. Choose a service for details and a direct request.
Explore the assembly3D / 360°
Drag to rotate · arrow keys and + / − also work
Services
Driveshaft manufacturing
Manufacture and assembly of cardan and drive shafts to agreed dimensions and application requirements.
Explore this serviceDriveshaft balancing
Dynamic balancing of assembled driveshafts up to 6 m long and 500 kg in mass. Mounting and operating speed are confirmed during technical assessment.
Explore this serviceRotor & turbine balancing
Dynamic balancing of rotors, fans, impellers and turbine rotors up to 500 kg, subject to technical review.
Explore this serviceMachining & fitting
Turning of shafts, bushings, flanges and mounting surfaces to drawings or measured dimensions.
Explore this serviceWelding & assembly
Welding and assembly of metal components with attention to alignment and the effects of heat.
Explore this serviceDiagnostics. Alignment. On-site service.
Vibration diagnostics and analysis
Vibration measurement and analysis for rotating equipment to identify likely causes and determine the next maintenance steps.
Explore this serviceLaser shaft alignment
Check and correct shaft alignment in motors, pumps, gearboxes and other coupled machinery.
Explore this serviceOn-site dynamic balancing
Balance a rotor in its own bearings at the operating site, following a review of feasibility and safe working conditions.
Explore this serviceEquipment vibration monitoring
Track equipment vibration over time through periodic measurements or a project for continuous monitoring.
Explore this serviceFrom your component
to an agreed result.
- 01
Request & input data
Equipment model, part number, drawing or sample. For repair, include symptoms and damage history.
- 02
Assessment & agreement
Inspection and measurements where needed. Choose repair or manufacture and agree dimensions, scope and terms.
- 03
Work & verification
Repair or manufacture to the agreed specification. Check geometry and connections, then balance the assembly.
- 04
Handover & records
Verify the result against agreed requirements and hand over the component and the agreed work records.
04 / Service request
Start with your part.
Tell us what needs balancing or repair. Feasibility, cost and timing are confirmed after review. Sending a request does not confirm acceptance of the part for work.
info@alwazen.com