Driveshaft repair
Repair and rebuilding using factory processes: inspection of joints, play and straightness, with component repair or replacement to the agreed scope.
Explore this serviceALWAZEN INDUSTRIES
Driveshafts.
Repair. Manufacture.
Balance.
Restore an existing shaft or manufacture a new one from a drawing, sample and agreed specification. For vehicles, off-highway machinery and industrial equipment.
Explore the assembly3D / 360°
Drag to rotate · arrow keys and + / − also work
ALWAZEN / INDUSTRIAL CARDAN SHAFTS
Industrial cardan shafts
Industrial drives deserve a separate specification. Explore configurations, reference tables and flange interfaces, then prepare your project data.
Open industrial catalogue Measure the shaft and both connections
Restore. Manufacture.
Verify the result.
First assess the condition and task. Then agree the method, work scope, price and timing.
Driveshaft manufacturing
Manufacture and assembly of cardan and drive shafts to agreed dimensions and application requirements.
Explore this serviceDriveshaft balancing
Dynamic balancing of assembled driveshafts up to 6 m long and 500 kg in mass. Mounting and operating speed are confirmed during technical assessment.
Explore this serviceJoints & supports
Inspect universal joints, bearings and intermediate supports. Match replacements to the dimensions and assembly design.
Splines & connections
Assess wear in splines, yokes and flanges. Determine repair or replacement feasibility after inspection.
Length & geometry
Assess shortening, lengthening or tube replacement for an agreed design, followed by geometry checks and balancing.
A design for your application.
Length, interfaces, working angles, torque and speed determine the configuration. The final selection follows engineering review.
Single-section shafts
A single shaft between two connection points.
Multi-section shafts
Assemblies with intermediate bearing supports.
Telescopic shafts
Shafts with axial length compensation.
CV & double-joint assemblies
Designs using constant-velocity or paired joints.
Fixed-length shafts
Without axial length compensation; confirm the distance between assemblies and installation conditions.
Short shafts
Compact connections between closely spaced assemblies; working angles and available space are key.
From a passenger vehicle
to an industrial drive.
Choose an application to start a request with the relevant input checklist. Work feasibility and acceptance requirements are agreed for each assembly.
Balancing capabilities
Limits apply to dynamic balancing. Acceptance also depends on geometry, support surfaces and safe mounting.
Assembly and exchange
Developing service around your driveshaft.
01 / ASSEMBLY
Two-hour assembly — our target
A target for an approved configuration when the necessary components are available. Diagnosis, custom manufacture and part procurement are assessed separately; timing is confirmed for each order before work starts.
Explore this service02 / TRADE-IN
Driveshaft trade-in
We are preparing an exchange programme: assess your old driveshaft and credit the agreed value towards a new one. Acceptance, valuation and exchange terms are confirmed individually.
Discuss an exchangeFrom your component
to an agreed result.
- 01
Request & input data
Equipment model, part number, drawing or sample. For repair, include symptoms and damage history.
- 02
Assessment & agreement
Inspection and measurements where needed. Choose repair or manufacture and agree dimensions, scope and terms.
- 03
Work & verification
Repair or manufacture to the agreed specification. Check geometry and connections, then balance the assembly.
- 04
Handover & records
Verify the result against agreed requirements and hand over the component and the agreed work records.
Before work begins.
Will balancing remove every vibration?
No. Joint wear, shaft damage, misalignment and support condition also need checking. The repair scope follows inspection.
Can you manufacture from a sample?
A sample or drawing can start the assessment. Mounting dimensions, application, torque and operating speed must be agreed before manufacture.
04 / Service request
Start with your part.
Tell us what needs balancing or repair. Feasibility, cost and timing are confirmed after review. Sending a request does not confirm acceptance of the part for work.
info@alwazen.com